[RepRap] Extruder Kit mounted

Closing screw I’ve just arrived few days ago at Madrid, and I’ve had the joy to received the RepRap Extruder Kit built this summer by RRRF!

The pieces are well cut, and there is some neat mechanical design (I’m new in this domain) helping to put pieces together.

The only issue has been the middle part, containing the driving screw, with one of the part just a millimeter short. It looks one-sided, if put on the wrong side, there’s a gap at the bottom of the piece near the plastic part.

Now, I’m just missing “40mm length of 3mm braided steel wire”, some “JB Weld high-temperature epoxy glue” to finish completely to assemble this extruder kit. Thanks to Fernando from Barcelona who gave me a ferreteria address to visit in Madrid to get this kind of pieces.

The next missing part is the PIC programmation, I’ve got some issue with the Olimex PG3B pogrammer and pkp (under Ubuntu), they seem unable to communicate, and the programmer board is stuck with PRG1 led once parallel port is open… Hope to solve this during the week before to leave to Berlin with everything connecting, and come back soon with all mechnaical parts!

About alx

No Comments

Be the first to start a conversation

Leave a Reply

  • (will not be published)